The NI GPIB-USB-HS+ with Controller NI-488.2 transforma cualquier PC con un puerto USB en un controlador IEEE488.2 completamente funcional para hasta 14 instrumentos GPIB programables. MEASUREMENT AND CALIBRATION INSTRUMENTS.LABORATORY, PHARMACY, MEDICINE AND HEALTH.I apologize for the long post, but i greatly appreciate any help. Have any of you experienced something similar, and is there a way to download older drivers without using an NI Service Request (due to being a student, i don't have a service program membership)? At this point i really do not know where to go, it has been almost two weeks since i attempted to fix this. Considering this is equipment purchased far before i even started studying i cannot really verify if it is genuine or not, only assume that it is considering the circumstances. Coincidentally NI has made all prior drivers unavailable for download. Through some research i discovered that this error only occurs when using NI 488.2 drivers version 17.6 and up, and was reported by people using genuine hardware. Following a troubleshooting guide from NI i installed the Measurement & Automation explorer and got an error stating that "this hardware is not genuine, Error code -37056". However, the very next day, as soon as i setup my PC and opened the channel, the RF generator wouldn't go further from being in the remote state. The RF generator immediately became a listener and there were no issues with sending commands and data through MATLAB. 17.6, followed by the Keysight IO Libraries Suite ver. My first attempt actually worked, which consisted of installing NI 488.2 runtime ver. The issue arises when it comes to the driver setup.
I was also provided with a NI GPIB-USB-HS controller for this. I have recently gotten an assignment as a student that requires me to use an Agilent e4433b RF signal generator to generate desired waveforms created in MATLAB. This is my first post here, and I'm really new to LabVIEW and the GPIB interface as a whole.
0 kommentar(er)
